3aciscoswitch.over-blog.com

A new switch, to do dhcp: 1, restore factory settings; 2, set the default vlan; 3, to the default VLAN address; 4, set the dhcp: Switch (Config) Ip Dhcp Pool IP03 Switch (Config-pool) Network 192.168.102.0 255.255.255.0 Switch (Config-pool) Dns-server...

Read more

Question: Pardon me for a newbie question. I have configured the box and done the usual wr, copy run start, and the box keeps coming up with the initial config dialog? What am I missing? Thanks for the help. Answer: Sounds like maybe your config register...

Read more

A new WS-C3750X-24S-S switch, to do dhcp: 1, restore factory settings; 2, set the default vlan; 3, to the default VLAN address; 4, set the dhcp: Switch (Config) Ip Dhcp Pool IP03 Switch (Config-pool) Network 192.168.102.0 255.255.255.0 Switch (Config-pool)...

Read more

The first step WS-C3750V2-24PS-S from switch; The second step; configuration 1) press the MODE key to the 3560 power. 2) select the first item in the menu that appears. System software: Flash_init Load_helper Boot Switch:flash_init Switch:load_helper...

Read more

The Cisco 3925 router switch> command line mode; config# privileged mode A, configure the switch VLAN mode; in two ways The first: Config#vlan ID ID here is your individual needs to divide the VLAN number Config-if#name name Switch#show VLAN brief VLAN...

Read more

Today to help Cisco 1900 colleagues to upgrade a Cisco 3560, the steps are as follows: 1, the configuration environment Can be replaced by the new IOS upload to the switch, to use the auxiliary tool,there are many tools, you can choose, I use a small...

Read more

Question: I am just WS-C3560V2-24TS-S being too curious here Looking at the outputs of the some commands like show memory, show region, show buffers etc on many different router models I could make out that IOS is using all 32-bit memory addresses. So...

Read more

Question: I have a Cisco 2901 WS-C3560X-24T-L and need to expose an internal resource to the outside. I've set up the following: ip nat inside source list 1 interface GigabitEthernet0/0 overload ip nat inside source static tcp 1.1.1.1 4000 2.2.2.2 4000...

Read more

Question: I have a P2P T1 between Cisco 3945 price locations, each router have two ethernet interfaces, one interface is configured for communitcations between locations for our phone system. What I am trying to achive here is to use the second interface...

Read more

Question: Anyone know if the Cisco Cisco 2901-SEC 1900 series routers will support 3 serial T1 links? I see th 1900 series routers have 2 WAN slots (EHWIC) and was thinking we could install a dual T1 card in one EHWIC slot and a single T1 card in the...

Read more