3aciscoswitch.over-blog.com

Question: hiiii guys i have aproblem with hub WS-C3750X-24P-L Price and spoke toplogy i have the toplogy shown above the hub is R16 ping all spoke but spoke not ping each other can any one help me note that i use multipoint configuration here is the configuration...

Read more

Question: This is something I'm looking to cisco price do on a weekend but am curious about its operation. I'm going to be created new VLANs and will need them to be routable. Therefore, I'm going to be creating VLAN interfaces for these VLANs. Our current...

Read more

Question: I have a router cisco c3825 WS-C3560X-24T-L Price with 256mb of ram and 64mb of flash memory. I need to setup a bgp instance but our asn it's in the new format (32bit). Can someone help me to understand what ios version support this ASN ? Now,...

Read more

Question: I am planning to WS-C3560X-24T-S Price deploye the fwsm with all this complexity anyone tell me please this type of senario work or not means traffic will move from msfc to the core.. Is this right to create another svi int2 on msfc to move...

Read more

Question: Network is Catalyst 3560V2 10.254.0.0/16 snag.gy/3Y8aN.jpg This is the network image. This is my subnetted connections: http://snag.gy/BeqUK.jpg I can ping R2 to R5 but not R5 to R2. I have spent about 10 hours going through my network and code...

Read more

Question: Can't get my router to work with the new WS-C3560X-48T-S Price settings that o2 have supplied/applied. It was a static IP but I've had them change it back to dynamic to see if maybe I can get it working with that. Below is the config I currently...

Read more

Question: We have a setup .. Two sites connected over MPLS link and WS-C3560V2-24TS-S both of the connected to P2P link as well for back link and we are running Eigrp over P2P link. P2P links terminated on switches at both ends and configured as Access...

Read more

Question: I am setting up my WS-C3560X-48PF-L Price ccnp home lab. I have 4*1841 with wic-2t(smart serial) installed, and 1*2610xm with nm-8a/s intalled. I want to use my 2610xm as frame relay switch. but when I tried to set the clock rate on the serial...

Read more

Question: For a 2900 connected to two ISP's, WS-C3750V2-48TS-S how can I load balance traffic from an inside ASA to the ISP's so that traffic is more or less evenly distributed and also failover is taken care of if one ISP goes down. Answer: This is often...

Read more

Question: Our security department wants me to Catalyst 3560V2 Price close tcp ports 2001,4001,6001 and 9001. Below is part of my configuration Interface Fastethernet0/0 IP address X.X.X.x ip access-group control out ip access-list extended control deny...

Read more